>
News Center
>
Lifting of conveyor belt

 Copyright © 2018 BAODING JINGBO RUBBER CO.,LTD  All Rights Reserved                                                           冀ICP备09014553号                                                                         Powered by www.300.cn

Online customer service
Customer service hotline
400-0123-599
Customer service team:
在线客服
Wangwang:
QQ:
QQ:
QQ:
QQ:
QQ:
Service time:
8:00 - 20:00

Lifting of conveyor belt

[Abstract]:
In the storage and use of the conveyor belt, if not properly, will shorten the service life of the conveyor belt, the worse it will cause damage to the conveyor belt, can not be normal use.

In the storage and use of the conveyor belt, if not properly, will shorten the service life of the conveyor belt, the worse it will cause damage to the conveyor belt, can not be normal use. Therefore, the conveyor belt manufacturers Baoding Huaxing Rubber Industry Co., Ltd. to remind us of the storage and use of the conveyor belt should pay attention to the following matters:

Lifting of conveyor belt

When the conveyor belt is used, it is better to use rope and steel bar. First, a steel rod passes through the core hole, and the rope with the supporting rod is hung at both ends of the steel rod to be lifted. When lifting, be careful not to damage the ropes. In the absence of steel bars and rods, a sufficient strength of the fabric rope can be lifted through the core hole. But with contact on the rope and place a pad object, prevent the rope with bad side. The sling can not be inserted into the coil to be lifted, and the rope can not be hung on the belt to prevent the belt from slipping to the side. It is also possible to use a forklift truck with sufficient carrying capacity to lift, but shall not damage the outer ring of the belt.