Nylon conveyor belt maintenance

Nylon conveyor belt during transportation and storage, should be kept clean to avoid direct sunlight or rain leaching, to prevent contact with acid, alkali, oil, organic solvents and other substances, and a heating device distance meters.

Nylon storage temperature should be maintained at a temperature of 18-40 DEG C, relative humidity should be maintained between 50- 80%.

Nylon during storage products to be placed into a roll, not folded, placed during turning once every quarter.

Nylon conveyor belts of different types and sizes should not be used together.

Nylon conveyor belt type, structure, specification, number of layers should be selected according to the conditions of use.

Nylon conveyor belt running speed should not be greater than 2.5 m / s, the block is large, the wear of the material and the use of fixed pear unloading device should be as low as possible.

The relation between the diameter of the transmission roller and the conveyor belt of the conveyor belt, the matching of the transmission roller, the roller and the requirements of the roller groove angle should be selected according to the design rules of the conveyor.

The feeding direction should be running direction of the belt for impact on belt reduce falling material should adopt the chute, reduce material falling distance. The tape material receiving section should shorten the distance between rollers and the buffer roller for leakage, with the adaptation of moderately soft block plate, so as to avoid gear plate is excellent, cut conveyor belt surface.

Nylon conveyor belt in use should pay attention to the following matters:

1. Avoid roller material is covered by rotary, prevent leakage between the drum and tape to card, pay attention to lubrication of the movable part, but not the oil conveying belt;

2. Avoid load start;

3. Belt deviation, take measures to correct application;

4. Find local repair tape made of cotton one application, so as not to expand;