>
News Center
>
Why is the conveyor belt easy to crack, disconnect

Information        Address        Recruit

Phtot

VR

LINKS:

Address: No. A 1, Daqi Road, China (Boye) Conveyor Belt Industrial Zone
Tel:+86-312-6784809(sale)  /  +86-312-8348888(factory)
Phone:+86-15175208899(sale)
Fax:+86-312-6784908(sale) /  +86-312-8349617(factory)  
Mailbox: 
info@hbjingbo.com (factory)  

 

保定京博橡胶有限公司

BAODING JINGBO RUBBER BELTS CO.,LTD

Profile        Speech        Culture

History        Cooperative        Honor

 Copyright © 2018 BAODING JINGBO RUBBER CO.,LTD  All Rights Reserved                                                           冀ICP备09014553号                                                                         Powered by www.300.cn

Online customer service
Customer service hotline
400-0123-599
Customer service team:
在线客服
Wangwang:
QQ:
QQ:
QQ:
QQ:
QQ:
Service time:
8:00 - 20:00

Why is the conveyor belt easy to crack, disconnect

[Abstract]:
The strength of the joint is lower than that of the normal belt. Generally connected by mechanical means, the joint strength can only reach 40 - 50% with body strength, cold bonding quality is better,

The strength of the joint is lower than that of the normal belt. Generally connected by mechanical means, the joint strength can only reach 40 - 50% with body strength, cold bonding quality is better, the joint strength can reach 60 - 70%, while the intensity of heat adhesive joint can reach 80 - 90% (joint method is correct, no quality defects). Because the strength of the joint is relatively low, if the bonding method is not correct, the strength of the joint will be lower. Such as surgery, grinding damage and a layer of cloth, excessive grinding, lap length is not enough, the step number is not enough, the rubber adhesive joint performance is not good or has been since sulfur failure, steel wire rope, wire rope and other excessive grinding rust, joint strength will be greatly reduced, when in use, prone to disconnect joint the phenomenon of.

In addition, if the conveyor belt does not use sealing glue, or the direction of the adhesive joint is wrong, the joints prone to cracking (surface area).